FERRET TYRE DEFLATOR

THE QUICKEST AIR-DOWN TOOL THERE IS!

DEFLATES AT 1 lb. PER SECOND:  e.g.  40psi to 18psi would take 22 seconds on an average-sized 4-wheel drive tyre, so you can deflate your tyres quickly and accurately with only ONE tool and ONE trip around the vehicle.

THE PRESSURE IS NOT PRE-SET:  You can release as much or as little air as the conditions require.  SIMPLE to operate, you can go from any pressure to any pressure you want, just by timing it or counting down the seconds, without the need for hoses or gauges. 

NO MORE LOST VALVES:  The deflator removes the valve and HOLDS it in the chamber, eliminating the risk of lost valves.  Valve re-seats perfectly every time, without disturbing or damaging the seals, and will not cross the threads on replacement.        

MAINTENANCE:  Tool is made of SOLID brass and MARINE-GRADE stainless-steel, contains no o-rings or seals and will not rust, leak or perish.  Can be washed out in water.  Fits on a key-ring. 

MANUFACTURE:  PRECISION-TURNED, each tool is individually hand-crafted in Western Australia and has a full replacement guarantee.  This tool is made to last you a lifetime!

TRACK RECORD:  The tool has been proven over ten years now and is being used by the Army, Fire Services, CALM, 4WD tours and bobcat operators.  On demonstrating at Perth and Brisbane national 4-Wheel Drive Shows, this deflator is very popular, due to its simple operation and rapid action.  It is now used by beach-fishers, campers and 4-wheel drivers who want to let their tyres down FAST, whether on sand or snow.

ITS REALLY EASY TO USE 

1.  Deflation is rapid (approx. 1lb/sec for normal tyres and just under 1lb/sec for large 4wd tyres) Monitor Deflation at all times.

2. Unscrew knurled end until screw pin slides freely out to its stop.

http://www.youtube.com/watch?v=Fc_hV1dgHW4

3. Screw valve tool all the way on to valve.

4. Locate inner valve with screw pin and turn anticlockwise until valve enters tool chamber, air will begin to vent from tyres.

         

5. When ready to terminate air flow, push screw pin in and turn clockwise until valve is screwed all the way back in and airflow stops.

6. Pull back screw pin all the way and unscrew tool from valve stem.

7. Replace screw pin in its thread, check for air leaks and replace valve cap. JOB DONE.

                                        Also Check out the Ferret Deflator Video HERE on YouTube

If interested in FERRET TYRE DEFLATORS or purchasing of item Contact:

ferret@e-wire.net.au

or

 check out the FERRET Ebay Store